Bravo Company Gunfighter Vertical Grip | Mod 3 | Black (Kodiak Edition)

The Bravo Company Gunfighter Vertical Grip Mod 3 Kodiak Edition delivers the proven Mod 3 formula in a black finish matched specifically to BCM’s limited edition Kodiak upper and lower receiver sets. If you are building a Kodiak rifle, this is the grip that finishes it without a color mismatch. If you are not, it is still just a very good Mod 3.

Matching accessories that meet the same quality bar as a limited run receiver set are genuinely hard to find. This one closes that gap.

The Kodiak Edition Bravo Company Gunfighter Vertical Grip Explained

Functionally it is everything the standard Mod 3 is. A rugged one piece grip in impact resistant polymer, M-LOK compatible, with a slim low profile body and the signature rearward angle that improves wrist alignment for fast, controlled shooting.

What changes is the finish. The Kodiak Edition black is matched to the receiver set BCM produced in limited numbers, so the whole rifle reads as one cohesive build rather than a collection of parts that happen to be dark.

Builders who care about that level of detail are exactly who this exists for, and there is nothing exclusive about where it works. It is an excellent choice on any M-LOK handguard that could use better support hand control.

Limited runs sell out and then leave owners hunting for parts that match. Buying the matched grip while it is available is the sensible move if the rest of your build is already Kodiak.

Bravo Company Gunfighter Vertical Grip Features and Build Details

• Kodiak Edition black finish matched to BCM’s limited edition receiver sets
• One piece construction in impact resistant polymer with no parts to fail
• Rearward angled geometry that improves wrist alignment and shot to shot control
• Slim, low profile body that adds control without adding bulk or snag points
• Grippy textured surface that keeps the support hand planted through recoil
• M-LOK compatible for direct mounting on any modern handguard

Specifications and What They Deliver

The material is impact resistant polymer, which is the entire reason these grips survive the sort of handling that snaps cheaper parts at the mounting boss. It absorbs impact and returns to shape instead of cracking.

The one piece design means there is no hinge, no latch and no insert. Fewer components is fewer failures, and on a grip that gets grabbed, levered and slammed against cover, that simplicity has real value.

M-LOK mounting attaches the grip through the handguard slots for a secure, low fit. The minimal footprint means it adds control without adding bulk or snag points, which keeps a compact rifle compact.

The grippy textured surface keeps your support hand planted through recoil and rough handling, wet or dry, gloved or bare. That texture is molded into the body, so it does not wear smooth the way applied grip tape does.

The rearward angle is the last piece. It puts the wrist in a stronger position for driving the rifle forward and back, which is what makes fast, controlled shooting repeatable rather than lucky.

Building With It, and Keeping It Running

Install the Bravo Company Gunfighter Vertical Grip into the M-LOK slots that match your reach, torque the hardware, and you are finished. Setting it where your hand naturally lands matters far more than any measurement someone else can give you.

There is no maintenance schedule to speak of. Wipe it, check the hardware occasionally, and otherwise leave it alone for years.

If the Kodiak build is still in progress, our grips and stocks category is worth a look for the stock and pistol grip to go with it.

Limited edition parts usually cost you either function or money. This one from Bravo Company costs you neither, delivering a matched finish on a grip that was already the right answer. Ships direct to your door, no FFL required.