Breakthrough Battle Born Grease 12cc Syringe – BTG-12cc

Breakthrough Battle Born Grease in a 12cc syringe is the answer for the handful of places on a firearm where oil simply runs off and leaves bare metal behind. Grease stays put. That is the entire argument for keeping a syringe of it on the bench, and the syringe format is what makes precise application possible instead of a knuckle-deep smear.

The 12cc size is deliberately small because you use very little at a time. A rice-grain portion on a bolt lug or a set of rails goes a long way, and a single syringe will service a rifle across a long stretch of range trips.

What Breakthrough Battle Born Grease Is and Who Needs It

Grease is a high-viscosity lubricant intended for high-pressure, low-speed contact points. On firearms that means bolt lugs, cam pins, camming surfaces, slide rails on some pistols, and the wear points where two hard surfaces grind against each other under load. Oil migrates away from those spots under recoil and gravity. Grease does not.

This makes Breakthrough Battle Born Grease especially useful for precision bolt-action shooters who want a smooth, consistent bolt throw, AR builders lubricating the bolt carrier group, and shotgunners servicing action bars. It also earns a place in a hunting kit, where a rifle may sit for days in cold, dusty conditions between shots and a light oil film would have long since drained away.

Key Features

• 12cc syringe applicator for controlled, precise placement with no waste
• High-viscosity grease that stays on the contact surface under load
• Ideal for bolt lugs, cam pins, rails, and other metal-on-metal wear points
• Compact enough to live in a range bag or a cleaning kit without taking up space
• Works alongside standard solvents and oils as part of a complete maintenance routine

Specifications and How Much You Actually Use

Twelve cubic centimeters sounds modest until you understand the correct dose. A proper grease application is a thin, even film that you can barely see, not a visible bead. Over-greasing does real harm: excess grease traps carbon fouling, unburned powder, and grit, and turns into an abrasive paste that accelerates wear instead of preventing it.

Use the syringe to lay a small line on the surface, then spread it with a fingertip, a patch, or a nylon brush until it disappears into a sheen. That is the target. When in doubt, less grease applied more often beats packing a bolt carrier full of it and hoping for the best.

Practical Use, Care, and Compatibility

Clean before you lubricate. Grease applied over old carbon simply seals the fouling against the metal. Degrease the part, dry it, then apply. On an AR bolt carrier group, the classic points are the bolt lugs, the cam pin and its channel, the area around the gas rings, and the rails of the carrier itself. On a bolt-action rifle, the lugs and the cocking cam are where a smooth action is won or lost.

Cap the syringe after each use so the tip does not collect dust, and store it upright at room temperature rather than in a hot vehicle. Wipe old grease off before reapplying rather than layering fresh over stale. Anywhere you would previously have used a heavy oil that kept disappearing, this is the better tool for the job.

Compatibility is broad because grease is a mechanical solution rather than a chemical one. Breakthrough Battle Born Grease works on steel, aluminum, and hard-anodized surfaces, and it plays well with the solvents and oils already in your kit as long as you clean between steps. Use it on rifles, pistols, and shotguns alike, and keep a second syringe in the truck bag for field repairs.

Round out the bench with brushes, patches, solvents, and rods from our apparel and gear department and you will have a complete maintenance station. Good lubrication is the cheapest reliability upgrade there is. Ships direct to your door, no FFL required.