Nightforce 30MM Ultralite Ring 1″ 6 Screw

The Nightforce Ultralite Ring Screw set in 30mm with a 1 inch height and six-screw caps gives you a light, low, and rock-solid scope mount for precision builds. Machined from 7075-T6 aluminum and fitted with titanium crossbolts and jaws, it holds like steel while shedding weight your rifle will thank you for. Shooters who want a low mount that never lets go choose the Nightforce Ultralite Ring Screw design for its blend of strength and restraint. It is a small part that makes a big difference in how your rifle holds zero.

What the Nightforce Ultralite Ring Screw Set Is and Who It Is For

This is a pair of 30mm rings at a low 1 inch height, using six cap screws for a secure, evenly distributed clamp. It suits shooters mounting a 30mm optic close to the bore for a natural cheek weld and fast, repeatable positions. The six-screw layout is the detail that separates a good mount from a great one, spreading pressure so the tube stays true.

Precision rifle shooters and hunters who value a light, low setup are the ideal fit. If you want your optic tucked in tight and locked down hard, this ring set was built for that job.

The six-screw top is the feature experienced shooters look for on a hard-use rifle. More fasteners mean the clamping load is spread across a wider footprint, which reduces stress on the scope tube and improves the odds of a lasting zero. It is a small design choice with an outsized effect on reliability.

Key Features

• 30mm ring diameter for the most common precision and hunting optics.
• Low 1 inch height keeps the scope close to the bore for a solid, natural cheek weld.
• Six-screw cap design distributes clamping force for a confident, even hold.
• Machined 7075-T6 hard anodized aluminum bodies deliver steel-like strength at half the weight.
• Titanium crossbolts and jaws provide serious clamping power with minimal mass.
• Construction offers strength well beyond that of ordinary lightweight rings.

Specifications and Build

The bodies are machined from 7075-T6 aluminum and hard anodized to resist wear and corrosion in the field. That aluminum grade carries a superb strength-to-weight ratio, which is why these rings can stay light without turning fragile. The titanium crossbolts and jaws handle the clamping, matching the performance of steel while trimming weight where it counts most.

A low 1 inch height keeps a 30mm scope snug to the rifle, improving consistency shot after shot. The six-screw caps take that a step further by spreading load across the tube for a hold you can trust under recoil. All told, this is strength well beyond what typical lightweight rings offer.

Practical Use, Care, and Compatibility

Mount these rings on a Picatinny rail, level the scope, and torque all six cap screws evenly in a cross pattern to the recommended specification. Even torque preserves the roundness of the tube and keeps the glass free of stress marks. Confirm crossbolt tension after your first few outings and recheck periodically on hard-kicking rifles.

Snug each screw in stages rather than tightening one fully before the next, so the cap seats evenly. Keep the gaps balanced side to side and avoid crushing the tube with excess torque. Done right, the rings clamp with authority and leave the scope free to perform.

Complete the build with a matching optic from our full optics collection, where rings, bases, and scopes all live together. The Nightforce name behind this set is a promise that it will survive far more than a range day. Install it properly and it becomes an invisible, dependable part of the rifle.

Low, light, and locked down, the Nightforce Ultralite Ring Screw set is a smart foundation for any precision optic. Ships direct to your door, no FFL required.